PDA

View Full Version : MDLops Help


Jedi Targus
07-20-2009, 08:45 PM
After exporting my models from NwMax i run them through MDLops, but sometimes it comes up with an error saying it couldn't read the MDX file. Does anyone know why or what i am doing wrong?

ROTNR
07-21-2009, 12:59 AM
hmm... not sure if you have this fixed or not since I just replied to your other thread, but what you will want to do is #1. Make sure you are NOT re-reading or writing your -ascii file. #2. Make sure that you save your new .mdl file to another location to avoid confusion #3. Click Read and Write
Again, not sure if you have this fixed or not, and I hope this helps you =),
-Pete