PDA

View Full Version : Force Speed Question


ItsNotMyFault
05-17-2002, 04:43 PM
Is there a way to turn off force speed about 1 second after you turn it on. I press F3 to start it then I press F3 again to stop it, but I guess F3 isnt a toggle. I just want a quick one second burst of speed without draining my force reserve.

Also, is there a list of console commands somewhere? I may program in a script.

fitzwilliamd
05-17-2002, 04:54 PM
No. After expending the 50 points of force pool, speed lasts for 10 seconds, 15 seconds, or 20 seconds at levels 1, 2, and 3 respectively; during this time your force pool will not refill.

I just want a quick one second burst of speed without draining my force reserve.

Trying rolling in the direction you wish to go; it is faster than running.

Also, is there a list of console commands somewhere? I may program in a script.

Try dropping to your console and typing: /cmdlist and /cvarlist

This should get you started. JO uses the Quake 3 engine and there are innumerable sites with comprehensive information on each command. Good luck!

:angel: