PDA

View Full Version : cloning question?


Takeoffyouhoser
11-17-2002, 03:08 AM
I made a switch that opens up a door. I was wondering, to save time, just clone this trigger and move it to where i have another door, will it still work properly on the new door?
or
Am i going to have to make seperate swtiches for each door i have.

lassev
11-17-2002, 07:49 AM
Eh? Just make sure the targets and targetnames are pointed and coming from right entities.

When you clone any entity with a targetname, the smart Radiant will either add number 1 in the end of the targetname or if you already have a number in the end, it will increase it by one. This must be taken into account. However, target key is not handled with number in such a way, but the target stays the same during cloning.

Any door - trigger - switch complex will work as long as the trigger is targeted at the right door and at the right switches.

To answer your question: clone the trigger, move in the vicinity of the other door and target it properly.