PDA

View Full Version : Func_plat...


Silas_Kar
04-02-2003, 01:46 PM
Ok I am trying to make an elevator going to my basement... There are two problrms I am having:
(1 The elevator always starts at the bottom of my elelvator shaft!
Is there any way to make it start at the top so you can just open a door step on press a button and go down?
and (2 When i call the elevator up so i can go down, I step on the elevator and it takes soooo long for it to go down, it works faster if i step off the elevator and get back on it (After I step off the elevator it starts going down! So I fall down the pit onto the elevator!) Can someone please help me?!

War Master
04-02-2003, 02:50 PM
I personally don't like func_plat, I can never get it to behave the way I want. Have you tried making your elevator with func_door?

wedge2211
04-02-2003, 05:00 PM
Try this: http://wso.williams.edu/~jshoer/elevator.htm

To make a func_plat start at the top and go down, you just give it a negative height value and position it at the bottom.

Leslie Judge
04-02-2003, 05:01 PM
Place the plat at the bottom position and give it a negative height value.


Ehh... slow... Cheers, wedge! :D

Silas_Kar
04-02-2003, 08:35 PM
Ok thank you guys!