View Single Post
Old 08-25-2008, 03:20 AM   #1
redrob41
Veteran
 
redrob41's Avatar
 
Join Date: Jul 2007
Location: Edmonton
Posts: 932
Current Game: just modding TSL
Veteran Modder Helpful! 
Tutorial: Photoshop Tricks for Character Skins

Original Thread

Well, I've been making quite a few skins and mods here now for over a year. Recently though, I was making some suggestions to a fellow modder, and he asked me to make a tutorial. I'll slowly add new posts for new tricks. The first one is fairly simple;

This is how I maintain shadows in newly textured areas:

Step 1: Open the file you want to work on (in this case P_BastilaBB01.tga). I usually save it right away as a Photoshop file, and rename it.
Show spoiler


Step 2: use the selection tools to outline the area you want to work on (see the dashed outline in the image above). Then create a new layer (for now it is called Layer 1 by default).
Show spoiler


Step 3: desaturate the new layer. This will make the layer appear as greyscale.
Show spoiler


Step 4: set layer 1’s Blend Mode to “Overlay”. This will make Layer 1 affect the layer directly below it. Now, the shadow areas will cause the layer below to become darker (aka “multiply”), and the highlight areas will cause the layer below to become lighter (aka “screen”). The closer to middle grey on this layer, the less the layer below is affected.
Show spoiler


Step 5: in order to increase the contrast, I usually use the Levels adjustment, so that I have a little more control.
Show spoiler


On the histogram in the middle, there are three sliders that control the Input Levels. By sliding the black one to the right, all the dark areas become darker. Sliding the white one to the left makes all the light areas whiter. When you slide the grey one to the left, more contrast. Slide it to the right, less contrast.
Show spoiler


Step 6: create any new texture you want on a new layer (in this case, a simple render clouds filter followed by the water paper filter). On its own, it looks fairly flat and lifeless. (I’ve also turned Layer 1 off for now.)
Show spoiler


Step 7: select the blank area of Layer 1.
Show spoiler


With this area selected, make Layer 2 active again. Then create a "Layer Mask". A layer mask controls layer transparency.
Show spoiler


Here you can see the layer mask as a little black & white picture next to the layer thumbnail. Basically, the white areas are 100% opaque (100% visible). The black areas are 0% opaque (0% visible). Any greys will be partially transparent. (Advanced: you can edit the mask by clicking on its thumbnail, and painting with white, or erasing with black.)
Show spoiler


Step 8: now that layer 1 is turned back on (renamed to Highlights & Shadows Layer) it will cause layer 2 (renamed to New Effect Layer) to have a little more three dimensionality instead of being relatively flat.
Show spoiler


Step 9: if the highlights and shadows seem too harsh or contrast, they can be readjusted using Levels again. Here, the bottom two sliders are used, and they change the Output Levels. As the black slider moves to the right, all the dark areas of the layer become more grey (lighter). Similarly, as the white slider moves to the left, all the white areas of the layer also become more grey (darker).
Show spoiler



- Major character artist for the Revenge of Revan mod. -
- List of Completed Mods - Work in Progress Thread - Skinning Tutorial -

Last edited by ChAiNz.2da; 08-25-2008 at 09:38 AM.
redrob41 is offline   you may: quote & reply,